0
Mcqs
Question & Answer
Q:

Two shafts with an included angle of 160° are connected by a Hooke’s joint. The driving shaft runs at a uniform speed of 1500 r.p.m. The driven shaft carries a flywheel of mass 12 kg and 100 mm radius of gyration. Find the maximum angular acceleration of the driven shaft.

A) 3090 rad/s˛ B) 4090 rad/s˛
C) 5090 rad/s˛ D) 6090 rad/s˛
 
Answer & Explanation Answer: A) 3090 rad/s˛

Explanation: Not available for this question

View Answer & Explanation

Category: Mechanical Engineering MCQs
Sub Category: Theory of Machines Mcqs

63
Related Questions
Q:

The angle between the axes of two shafts connected by Hooke’s joint is 18°. Determine the angle turned through by the driving shaft when the velocity ratio is maximum.

Q:

Which law states the when a number of loads are acting on a body, the resulting strain, according to principle of superposition, will be the algebraic sum of strains caused by individual loads?

Q:

How the total strain in any body subjected to different loads at different sections can be calculated?

Q:

Three sections in a beam are of equal length of 100mm. All three sections are pulled axially with 50kN and due to it elongated by 0.2mm. What will be the resultant strain in the beam?

Q:

Two sections in a bar of length 10cm and 20cm respectively are pulled axially. It causes an elongation of 0.2mm and 0.4mm respectively in each section. What will be the resultant strain in the bar?

Q:

A composite bar have four sections each of length 100mm, 150mm, 200mm, 250mm. When force is applied, all the sections causes an elongation of 0.1mm. What will the resultant strain in the bar?

Q:

A brass bar, having cross sectional area of 100mm2, is subjected to axial force of 50kN. The length of two sections is 100mm and 200mm respectively. What will be the total elongation of bar if E = 1.05 x 105 N/mm2 ?

Q:

A composite bar having two sections of cross-sectional area 100mm˛ and 200mm˛ respectively. The length of both the sections is 100mm. What will be the total elongation of bar if it is subjected to axial force of 100kN and E = 105 N/mm˛?

Q:

A bar having two sections of cross sectional area of 100mm˛ and 200mm˛ respectively. The length of both the sections is 200mm. What will be the total strain in the bar if it is subjected to axial force of 100kN and E = 105 N/mm˛?

Q:

A brass bar, having cross sectional area of 150mm˛, is subjected to axial force of 50kN. What will be the total strain of bar if E= 1.05 x 104 N/mm˛?

Comment Section

Recent Comments